 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
| The following Japanese famous hobby stores are written in English and can
ship to oversea! |
 |
|
  |
|
 |
|
 |
|
|
|
| Used Fujimi 1/24 Uma Uma Decal and 1/24 Ferrari F430 Spider |
| Fujimi 1/24 Uma Uma Ferrari (Ferrari F430 Spider) |
|
 Step 2 : Interior and Exterior
 Mesh Grills
I cut the mesh grills of the both side of the engine hood.
I cut the mesh grills of between tail lights and between Right and left mufflers..
Put the photoetch "Fine Molds AE-12 Metal Mesh #09 mesh Lozenge"to
the intakes of front bumper.
Cabin
The corners of the interior are square-built than real car. I sandpapered
the corners.
The shape of back side of cabin is wrong. I plane the mold.
Cut the beams from the doors.
I sandwiched the spacers between beams and back side to adjust the beams
at the right position.
I corrected the shape of bulges.
Scratch Build the Omitted Parts
I made the correct shape part of back side.
I made the glove compartment on back side.
I made the beams with retractor seat belt.
Test assembled the scratch build parts.
Windshield and Peripheral Parts
The inner part of front pillar is omitted. I replicated it, spot lamp and
sun visors.
Replicated the super tweeter panels the inside of door mirrors.
I temporarily assembled self-made parts.
Steering column
I puttied the blow molding of the underside of steering column, and replicated
the bulge of Ignition key cylinder. Column levers were remade of brass
line.
Temporary assembling figure.
Map pockets
I scratched build the map pockets on back side of cabin. The net parts
are the photoetch "Fine Molds AE-12 Metal Mesh #09 mesh Lozenge".
Temporary assembling figure.
Peripheral Parts of the Floor
I replicated the footrest of passenger's seat of the photoetch "FineMolds
AG05 Metal Belt (Circle Hole Narrow) Stainless Steel t-0.15mm" .
Replicated the floor mats of the sandpaper.
|
|
